6/10/2023 0 Comments Actions server pluginentity-undo-weight: default: 1 villager: 5 # These settings concern when we should exclude a mob from having actions applied to them. # * If an entity type is not specified, the value under default will be used. untrigger-settings: # How many cycles of the reactive mode being untriggered should have to pass before any actions are undone? minimum-cycles-before-undo: 10 # At most how many mobs should have their actions undone per cycle? maximum-undos-per-cycle: 40 # How much should an entity contribute to the maximum-undos-per-cycle limit? # * For example, if maximum-undos-per-cycle was 40 and the entity-undo-weight for villagers was 5, at most 8 # villagers could have their actions undone (since 5 * 8 = 40). reactive-mode-settings: # Above what MSPT should the reactive mode be triggered? trigger-mspt-threshold: 45.0 # Below what MSPT should the reactive mode be untriggered, and actions undone? untrigger-mspt-threshold: 35.0 # These settings concern how the plugin should handle undoing actions performed on mobs once the reactive mode has # been untriggered. reactive: # - hard-nerf-animal-farms # - freeze-animal-farms # These settings concern the reactive mode for triggering profile check / action cycles. That said, there are some reasonable use cases for this mode, such as # allowing your players to keep larger farms at the cost of nerfing them when performance begins to degrade. # * Note: It is generally preferable to ensure your server's performance doesn't degrade in the first place, # rather than try to mitigate it. proactive: - soft-nerf-animal-farms # - soft-limit-animal-farms # - soft-limit-villager-breeders # - trim-animal-farms # - trim-sparse-animal-farms # These profiles only run when the server is performing poorly and are progressively undone as performance # improves (as defined under the reactive-mode-settings). world-settings: default: # Which profiles (as given in profiles.yml) should we run? profiles: # These profiles are constantly run. # * Note: If a world is not specified or if a setting is missing, it will use the settings listed under the default # section. start-up-delay: 0 # These settings can be specified per world. # Plugin page: # GitHub: # Please don't change this! version: 7 # Every how many ticks should we run the profile check / action cycle? cycle-period: 600 # How long in ticks should we wait before starting the checking tasks following the plugin's start up? # * This is useful when using the 'reactive' mode where it is desirable to ignore the server's performance in the first # few minutes following a restart. There is much to configure with this plugin config.yml # Configuration for FarmControl. By default, the plugin will only remove the random movement capabilities of and disable collisions for mobs in animal farms. To install the plugin, simply place the downloaded jar into your plugin directory.īe sure to configure the plugin by looking through its config.yml and profiles.yml, both located in the FarmControl folder of your plugin directory. Low impact - with the brunt of the plugin's processing performed asynchronously.
0 Comments
Leave a Reply. |